Chemical Manufacturing Applications for 2-Wire Coriolis Measurement

As reported by the Automation Gear blog, a big breakthrough has come to Micro Motion Coriolis flow meters. They can now be powered with two wires. These same wires carry the process variable and digitally communicate other process variables back to the process automation system via HART.

I did some reading and learned that that ultra-low power technology in the transmitter coupled with an optimized Coriolis sensor design made it possible to power these flow and density meters on a 4-20mA HART signal. Process manufacturers should continue use the 4-wire design for the real demanding applications like fiscal metering and custody transfer, meter verification and ones with entrained air.

Outside of these demanding applications, many mass flow, volume flow, density and temperature applications are well suited for the 2-wire Coriolis meter.

I caught up with Tom O’Banion, who leads the chemical industry efforts in Emerson’s Micro Motion division. He noted that Coriolis technology has increasingly been used to measure liquids and gases because of its accuracy and reliability compared with other flow measurement technologies.

With units typically spread over great distances, installation costs have been one limiting factor in the use of Coriolis technology. Tom noted one refiner’s estimate of $15 per foot plus labor for the cost of pulling the additional power wires needed for the 4-wire transmitter. This can add up quickly in tank farm or hydrogen metering applications that are typically long distances from the rack room.

Many natural gas metering stations on individual units were installed when natural gas was inexpensive–$1/Mscf. With prices now closer to $8/Mscf, chemical manufacturers and refiners want to track natural gas usage much more closely to optimize their operating costs. A typical small ethylene cracker may consume $200-$300 million in natural gas per year. Instead of differential pressure across orifice plates or turbine meters, a two-wire Coriolis meter can more accurately measure natural gas consumption and provide the flow, density and temperature measurements via HART back to the automation system for tighter control.

Another application Tom mentioned is hydrogen metering. It is usually located along the perimeter of the refinery. It’s very expensive and quite difficult to measure with conventional technologies. Using the existing wiring, the 2-wire Coriolis meter provides more accuracy and less maintenance.

Tom also noted that installation costs with the additional wires sometimes prevented the use of Coriolis technology in applications for which it was better suited–especially if the analysis had been based on installed costs rather than lifecycle costs (which favors Coriolis technology with no moving parts.) The two-wire version shrinks the installed cost difference.

It’s great that technology continues to advance to create more opportunities to optimize and save energy. I’ll continue to pass along applications as I come across them.

Posted Thursday, September 11th, 2008 under Chemical, Energy, Measurement, Refining.

Leave a Reply